Aigner

The universal basic element on spindle milling machines with integrated sliding table for supporting safety and working units. Mounting rail V - II Right

For attaching the angle bracket in T-slots of machine table and slides.

An important basic unit to provide a low friction side pressure on the work piece passing through (or top) the machine. Adjustment range between 5mm and 630mm with Allen key.

A further possibility for providing guidance and support.

For safe feeding of workpieces on circular saws, panel saws, narrow bandsaws and vertical spindle milling machines.

Universally usable with feeding blocks, easily attached and removed.

The universally usable pressure element for precise guidance; simple and fast insertion into the pressure module.

For use where a precise finish and pressure is needed when machining coated materials in timber and plastic material.

This block is for use where the Centrex is to be mounted on the back of the fence structure. Please check catalog for additional sizes

A device to allow short or thin pieces to be sawn using a work holder and side pressure.

Indispensable when machining small unstable work pieces, with use on the integral fence

Replacement strip for integral fence. Not the same as bottom strip

For mounting the Centrex on the machine table when the size or strength of the fence housing prevents its attachment. 355 Inner width (optional 500mm)

These are required when mounting the Centrex and supporting bridge on a machine table when it may be necessary to fold the unit away.

Table extension with 830mm mounting rail only